Usually, when I engage the auger, that B cable, it has a round eye that connects to the spring that is connected to the other auger cable, does not seem to be operating correctly.Snow blower problem? We have the solution. I then began to check the other auger cable, I believe its called the B cable and it appears not to be functioning properly. I checked shear pins, they are fine, I checked the auger cable, right side, from the handle to the bottom of the frame and that is fine. The next day I started her up to finish cleaning up a little and when I pressed the auger handle down, the auger would not engage. I have a Murray Snowblower, Model G2784000 Code:6239 with a Tecumseh 8HP Model HMSK80.Īfter the last snow storm, I finished the driveway and everything was fine. Pulled valve cover both valves moving and push rods in place. Was using blowing snow, worked well for a few hours and then starting stalling almost like starving for gas. I have a 10 year old MTD snow blower with a 5hp tecumseh engine. If so you will need to remove the fuel bowl and check the float and needle valve to see that they move freely and there is no dirt on the needle valve or needle valve seat which is also a soft material to help seal the gas inlet. Just keep an eye on the gas for leaks so that it does not start leaking again. The current fuels have some cleaners in them that will take care of any minor problems such as this.
Most likely no harm was done and its not broken, but it is a new unit and you should not have any doubts about it being in perfect condition the first time using it.Īfter the present fuel you installed soaked the area the float of needle valve loosen up so the leak stopped.Ĭheck you oil level in the engine to see that you did not get some gas in the crankcase. Is it watery or very diluted Does it have a gasoline smell to it If this is a brand new unit, then take it back for a replacement. If your oil level is high drain it and replace with fresh oil.ĭoes your snow blower have a fuel shutoff valve If so make sure you turn it off when you are not using the blower.
Sometimes that gas makes it into the cylinder and seeps past the rings and into the crank case dilluting the oil. The float and needle valve in the carburetor was probably stuck and fuel drained down from the tank and past the carburetor.
0 kommentar(er)
